Contact information
Karl Martin trading as LEI Safety Solution
Mobile: 07808196169
Email: enquiry.leisafetysolutions@outlook.com
Initial Approach on Site
Once an engineer enters a site, they must sign in and fill out any relevant paperwork. They will explain purpose of work to be carried out. They will then get familiar with safety protocols including meeting zones in case of a fire alarm. All our engineers will follow onsite health & safety procedures. We will then ask the POC (point of contact) to accompany our engineer around the site to highlight out any sensitive areas and confirm any arrangements/appropriate times that have been made for shutting down any equipment. This person will be advised of any concerns and items that fail. You should have an agreed location on site to put failed items, providing it is safe for both client and engineer. This will prevent unsafe appliances from being used after testing.
Standards for Testing
All engineers will hold a City & Guilds 2377 qualification as standard. Inspection & testing will be carried out in accordance with IET Code of Practice for In-service Inspection & Testing of Electrical Equipment. This includes the following types of electrical equipment as detailed in the IET Code of Practice: fixed appliances, stationary appliances, IT appliances, portable appliances, cables, chargers and handheld appliances.
Equipment Identification
For each appliance, a decision shall be made as to which tests are appropriate depending on the type of equipment, e.g., Class 1, Class 2 or Class 3
Inspection
A visual inspection of the appliance will be carried out prior to any testing. The inspection includes the following: The appliance – the appliance’s external case is inspected to ensure it is free from damage, cracks, etc., that could allow access to live parts. Plug – this is examined to ensure it is in physically good condition, is free from cracks, or damage and signs of overheating, and that the pins are insulated. The plug top is removed when appropriate to establish if the outer sheath of the flexible cable is securely gripped by the cable clamp, the terminals sufficiently tightened, and the plug is wired correctly. The fuse is examined to ensure it is of the correct rating for the type of appliance and not damaged. Flex – Make sure its length is suitable and safe for the appliance and the way it is used; it is in good condition and free from exposed wires, fraying or damage.
Testing
Subject to a satisfactory visual inspection, the following tests will be carried out were relevant:
EARTH CONTINUITY TEST – Applies to Class 1 items
INSULATION RESISTANCE TEST – Applies to Class 1 and Class 2
POLARITY TEST – Applies to power cables and extension cables
MICROWAVE EMISSION TEST – Microwaves will receive both Earth continuity test and an emission test
MINOR REPAIRS
Where possible, repairs such as plug replacement, fuse replacement or cable reduction will be done to ensure you equipment can pass the PAT. All minor repairs are free of charge.
Labelling
Each piece of equipment will be labelled with a unique Appliance ID number; this will be used to identify it against the test results report. For appliances that pass the Inspection and Test, a ‘Pass’ label will be attached stating the date tested, along with the initials of the engineer conducting the testing. Failed appliances will be labelled with a ‘Failed’ label, then removed from service and brought to the attention of the client representative on site.
Documentation
On completion of testing, a report will be issued listing all items tested by appliance ID number, description, location at the time of testing, engineer initials, any repairs carried out and the result of all tests performed. Microwaves emission tests will be listed separately. Any Appliances that fail testing will be listed separately and highlighted in red. This report will be produced along side a PAT test completion certificate as a digital copy.